Download b link brave51039/17/2023 Once the LED flashes complete, connect to BlinkX's WiFi and navigate to the BlinkX UI page to verify the update.BlinkX will not be able to read the file if the USB drive isnot using the FAT32 format or theupdate filename has been changed from blinkx_update.bin When updating the firmware, if the LED flashes red twice when power is connected, this is an indication that BlinkX cannot read the file from the USB drive. Any number of Red LED flashes indicates an error has occurred.Green flash three times: Firmware successfully installed.Magenta flash continuously every 0.25 seconds: Firmware from internal Blink storage is installing.Green flash twice: Firmware successfully stored.Magenta flash continuously every 0.25 seconds: Firmware from the USB flash drive is transferring to Blink storage.During the firmware update, the LED will follow the pattern below. BlinkX will start the update immediately.Finally connect the last end of the USB OTG cable to a power source such as a mobile phone USB charger/USB battery pack/Laptop, etc.BlinkX should not be connected to the GoPro camera during the firmware update process. Connect the flash drive to one end of the USB OTG Cable and the other end to BlinkX.The USB flash drive must be using the FAT32 file saving format * (typically the default format for USB drives 32GB or less). Download the blinkx_update.bin file and transfer it to the root folder of a USB flash drive.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |